- #DELL EMC CUSTOMIZED VMWARE ESXI 6.7 U3 A02 IMAGE INSTALL#
- #DELL EMC CUSTOMIZED VMWARE ESXI 6.7 U3 A02 IMAGE UPDATE#
- #DELL EMC CUSTOMIZED VMWARE ESXI 6.7 U3 A02 IMAGE PATCH#
- #DELL EMC CUSTOMIZED VMWARE ESXI 6.7 U3 A02 IMAGE UPGRADE#
My homelab is a simple Dell Optiplex and is officially unsupported, but works flawlessy. Is it inoperable/buggy on 6.5, or just unsupported?
#DELL EMC CUSTOMIZED VMWARE ESXI 6.7 U3 A02 IMAGE UPDATE#
Instead, consider to update/patch the host to ESXi 6.0 Update 3 which contains the mentioned fixes too.ĭang! Good to know. Please note that the R710 model is not supported with ESXi 6.5.
#DELL EMC CUSTOMIZED VMWARE ESXI 6.7 U3 A02 IMAGE INSTALL#
It was, but the host was wiped with a fresh 6.0 install (networking/config was a.p. If this was previous a 5.0/5.5, ESXi leaves somethimes old versions behind which are incompatble with 6.5 because they are not automaticly removed for unknow reaseons. I've not upgraded VMware (myself) yet in this fashion, is your networking/config retained, or completely wiped like a fresh install? I always use the Dell Custom ISO for new installation as well when upgrading to a new major release like 6.0* -> 6.5 Thank you both for the useful IRIX201110141 Or esxcli software sources profile list -depot=Ī rep on Dell's forum says using the VMware depot is OK, but has anyone tried this? Ideally, I'd like to not lose my networking or config, otherwise I'd flash an ISO. I can visit them direct and they're fine, but once I run:Įsxcli software sources profile list -depot= However, my homelab doesn't run the custom Dell image.
#DELL EMC CUSTOMIZED VMWARE ESXI 6.7 U3 A02 IMAGE UPGRADE#
I did a test run (6.5 -> 6.5 patch) via CLI on my homelab and the upgrade went smoothly.